TRED has released two new mounting adapters for the existing TPMK mounting kit that allow either side (35-TPMKBA01) or flat mounting.

TRED is known for being innovative and building products from the materials they know best. So TRED introduces two adapter mounts made of glass reinforced nylon, a similar material to the famous ARB TRED PRO Recovery board, but with an an even higher concentration of glass to improve strength.

The use of this material provides a lighter and more flexible solution to keep your recovery boards within reach and not interfere with the load on your vehicle's roof rack.

Made in Brisbane (Australia) from high quality material, suitable for extreme weather conditions worldwide. The screw set is made of stainless steel.

The TRED adapter kits are used in conjunction with the TRED PRO mounting kit the (35-TPMK) allows the ARB TRED PRO recovery boards on both sides of the ARB Trade Rack.

Alternatively, you can use the cross carrier of the ARB Trade Rack, Flat Rack Cab Rack or Touring.

Specially designed adapter for use in conjunction with TRED mounting kits for flat mounting of recovery boards on a roof rack where there are 25mm cross carrier tubes under the mesh. If there is no mesh on the roof rack, additional struts may be required to prevent twisting and the supplied hardware may need to be shortened to provide a clean finish.

Features:

• Designed for use with TRED PRO mounting
  
• High strength nylon
  
• UV resistant
  
• Stainless steel screws
  
• Made in Australia
  

Kit 1 - TRED Mount Base Plate Adapter Kit - Flat Mount

Kit includes:

• 1x TRED U mount
  
• 1x TRED lower hook holder
  
• 4x M5 x 35 mm stainless steel hexagon socket screws
  
• 4x M5 stainless steel Nyloc nuts
  
• 4x M5 stainless steel washers
  
• 1x M6 stainless steel Nyloc nuts
  
• 1x M6 x 35 mm stainless steel hexagon socket screws
  
• 1x M6 stainless steel washers
  

Please note:
Depending on the assembly, two kits may be required. One kit consists of one adapter.